How to remove bristan mixer tap head
Introduction
The Bristan mixer tap head is commonly found in many households and provides a convenient way to control the water temperature and flow in the kitchen and bathroom sinks. However, there may come a time when the tap head needs to be replaced or repaired. In this guide, we will walk you through the step-by-step process of removing the Bristan mixer tap head.
Tools and Materials Needed
- Adjustable wrench
- Flathead screwdriver
- Replacement Bristan mixer tap head
- Teflon tape
Step 1: Turn Off the Water Supply
Before starting any work, it’s essential to turn off the water supply to prevent any accidental leaks or water damage. Locate the shutoff valves underneath the sink and turn them clockwise to shut off the water supply.
Step 2: Remove the Handle
First, locate the small screw on the back or underside of the handle and loosen it using a flathead screwdriver. Once the screw is loose, you can easily slide the handle off the faucet body.
Step 3: Unscrew the Bonnet and Valve
With the handle removed, you’ll see the bonnet and valve assembly. Use an adjustable wrench to loosen and unscrew the bonnet counterclockwise. Once the bonnet is removed, you’ll have access to the valve.
Step 4: Disconnect the Valve
Using the adjustable wrench again, carefully disconnect the valve by unscrewing it from the faucet body. Be gentle to avoid damaging any surrounding parts.
Step 5: Install the Replacement Tap Head
Now that the old tap head is successfully removed, it’s time to install the replacement Bristan mixer tap head. Start by applying a layer of Teflon tape to the valve threads to ensure a tight and waterproof seal. Then, screw the replacement tap head onto the valve until it is securely fitted.
Step 6: Reassemble the Faucet
Once the replacement tap head is installed, reconnect the valve to the faucet body by screwing it back in with the adjustable wrench. Then, reattach the bonnet and tighten it clockwise. Finally, slide the handle back onto the faucet body and secure it with the small screw.
Step 7: Restore Water Supply
Turn on the water supply by opening the shutoff valves counterclockwise. Check for any leaks around the replaced tap head and make sure everything is functioning properly.
Conclusion
Removing the Bristan mixer tap head may seem like a daunting task, but following these simple steps can make the process quick and straightforward. Always remember to turn off the water supply before starting any work and take your time to ensure a proper replacement of the tap head. If you encounter any difficulties or are unsure about any step, it’s best to consult a professional plumber for assistance.
Step-by-Step Guide on Removing the Bristan Mixer Tap Head
Step 1: Locate the screw on the tap head. This is usually hidden behind a small cap that can be easily pried off with a flathead screwdriver.
Step 2: Use the appropriate screwdriver (usually a cross-head or flathead) to unscrew the screw in a counterclockwise direction until it is fully released from the tap head.
Step 3: Once the screw is removed, gently grip the tap head with your hand and carefully twist it in a counterclockwise direction to loosen it from the base.
Step 4: If the tap head is tightly stuck, you can use a pliers or an adjustable wrench to grip the base of the tap head and provide extra leverage while twisting it off.
Step 5: Continue twisting the tap head until it is completely removed from the base. Be cautious not to apply too much force, as this can cause damage to the tap or plumbing.
Step 6: Once the tap head is removed, you can now access the washer or cartridge inside for cleaning or replacement.
Note: It is always recommended to turn off the water supply before attempting to remove any tap head to avoid potential water damage.