How to change a brita water filter
Step 1: Gather all necessary materials
Before you begin the process of changing your Brita water filter, make sure you have all the necessary materials. This includes a new Brita filter cartridge, a pitcher or dispenser with a filter indicator, and a faucet with a detachable aerator.
Step 2: Prepare the new filter
Start by soaking the new filter cartridge in cold water for approximately 15 minutes. This will help activate the carbon filter inside.
Step 3: Remove the old filter
Next, remove the lid from your pitcher or dispenser and carefully take out the old filter cartridge. You may need to twist it counterclockwise or pull it straight up, depending on the model.
Note: If your faucet has a built-in filter, refer to the manufacturer’s instructions for removing the old filter.
Step 4: Insert the new filter
Insert the prepared new filter cartridge into the empty slot in your pitcher or dispenser. Make sure it fits securely and snugly.
Step 5: Reset the filter indicator
If your pitcher or dispenser has a filter indicator, follow the instructions to reset the indicator light. This will ensure accurate filter status information for future use.
Step 6: Rinse the new filter
Run cold water through the new filter for approximately 15 seconds to activate the carbon filter and remove any loose carbon particles.
Step 7: Enjoy fresh, filtered water
Your Brita water filter is now ready to use. Pour tap water into the pitcher or dispenser and enjoy clean and refreshing water that is free of impurities.
Remember: It is recommended to change your Brita filter cartridge every 40 gallons or about every two months. Regularly replacing the filter will ensure the best tasting water.
Step-by-Step Guide
To change a Brita water filter, follow these steps:
- Remove the old filter from the pitcher by pulling the filter cartridge holder upwards.
- Discard the old filter and rinse out the filter pitcher to remove any residual particles.
- Soak the new Brita filter in cold water for approximately 15 minutes before using it for the first time. This will help to activate the carbon in the filter.
- Insert the new filter into the pitcher, making sure it is sitting properly in the filter cartridge holder.
- Press the filter cartridge holder firmly down until you hear a click, indicating that the filter is securely in place.
- Fill the pitcher with cold tap water, allowing it to flow through the filter and into the reservoir. Do not fill beyond the max fill line.
- Wait for the water to filter through the cartridge, which may take a few minutes depending on the size of the pitcher and how much water you are filtering.
- Pour the filtered water into a glass or container and enjoy!
Remember to replace your Brita filter every 40 gallons or roughly every 2 months to ensure optimal performance.